Hello everyone,
I am quite new with Labview and APT so I would really appreciate your help. I installed Labview 16 (64-bit) on my 64 OS laptop. I have a new set up in my lab with a BSC203 controller and I am trying to connect everything together. After installing APT software from disk provided by Thorlabs, I wasn't able to find and insert MG17 Motor as an ActiveX in my Labview code. Therefore, I uninstalled the disk version of APT and downloaded the 64-bit version provided by Thorlabs site. That worked perfectly for the Labview, since I could find the MG17. However, APT User and APT Config still are not working. When I am trying to create a simulating configuration in APT I am not able to find as an option the 3Ch Stepper Driver BSC203 as a control unit. Can someone please help me figure out the problem?
Thank you very much for your time.
Kindest regards,
Eleni F