Hello,
I am relatively new to LabVIEW, and I have run into a rather frustrating problem...
I have a VI that drives a stepper motor. It was working fine until I rebooted. When I tried to run the VI again after rebooting, I was met with error code -70012 and the error message "motion: illegal board ID. You must use the board ID assigned to your controller in Measurement and Automation Explorer".
I thought that was rather odd, especially since it was working before the reboot. When I tried to access a test panel for the PXI-7342 through NI MAX, MAX froze and gave me an unsepcified error message.
In my VI, the board ID is specified as a strict type definition.
My equipment:
PXI-7342 (Two Axis Servo/Stepper Controller)
MID-7602 (2 Axis integrated power unit)
PXI-8119 (Controller)
Also, I cannot seem to get the Driver Fault Output (red) and Driver Inhibit (yellow) lights on the MID-7602 to turn off. The lights are on for all axis, even though I only have a stepper connected to axis 1.
I have tried re-installing the NI motion hardware.
The PXI-8119 is a non-networked machine, so I doubt if there were any updates that originited from online that got incorporated without my knowledge.
Thank you for any help! It will be much appreciated.