Hello!
Last time I was testing a new step motor controller. I discovered, that when I set the velocity higher than 2000steps/s, the speed doesn't increase more than 1968steps/s. I tried to set many configurations but they didn't work properly. I must do some tests with velocity much higher than 2000steps/s... Could you tell me what do I wrong?
Simple program was created in Labview 2011
Vision and Motion drivers -> NIMotion830
NI card -> NI-7334
Universal Motion Interface - UMI-7764
Windows XP
I tried only to set velocity of stepper motor in open loop.
Thank you in advance
Regards,
Mariusz