Hi!
I want to drive a hybrid bipolar stepper motor using a motor driver, a usb-daqpad 6016 and labview 2012 software as the user-interface. The motor driver that I use has 3 pins; enable, direction and pulse. My problem is I'm not sure how can I program the labview for clockwise (CW) and counterclockwise (CCW) direction. I can use the counter to send the pulses to the motor driver Pulse pin and probably wire the digital output to Enable pin to on and off the motor. But how about changing the motor direction; CW and CCW. Please advice me on this matter. Thank you.
I want to drive a hybrid bipolar stepper motor using a motor driver, a usb-daqpad 6016 and labview 2012 software as the user-interface. The motor driver that I use has 3 pins; enable, direction and pulse. My problem is I'm not sure how can I program the labview for clockwise (CW) and counterclockwise (CCW) direction. I can use the counter to send the pulses to the motor driver Pulse pin and probably wire the digital output to Enable pin to on and off the motor. But how about changing the motor direction; CW and CCW. Please advice me on this matter. Thank you.