Problem with setting velocity, acceleration, decceleration in rpm (rpms/sec)

Dear NI community,

let me, please, ask you about the following.

I want to specify velocity, accel/deccel in rpm (rpms/sec). For this, I'm using "Load Accel/Decel in RPS/sec", and "Load Velocity in RPM". As it is stated in Help files, before setting of these parameters, I use "Load Counts/Steps per Revolution", and specify 2000 - the same, as I have in NI MAX.
But the problem is, that speed and accel/deccel in LabVIEW application is not the same (much slower), than when I try to move motor via NI MAX (with the same values of speed, and others).

Could you, please, check the code, and tell, what I have to add more, to make it working properly?

Thanks a lot in advance!